Problem of the lift of Er'cana

[Chiro]

If you are not sure if something is a bug or not, you can make a forum post and discuss it before submitting a ticket, if you wish.

Let me report it here before submitting a ticket.

I leave the control room and go to pellets molding machine.
When I turn on the power switch in the entrance of pellet oven control room and am going to advance to a circular lift in the front, I cannot go ahead before.

I continue running on the spot. I cannot go ahead before when I do not continue running.

Then, I push a certain white switch on a cone and raise a lift.
Then I leave this lift this time and cannot go out.
Here, I continue running.　And I go out somehow.

I cannot step on this lift again when I go out once.
In this way, I cannot perform the comings and goings to this circular lift platform smoothly.

I’m sorry. My explanation may not be good.

[Tai'lahr]

Hi Chiro. This sounds like the "sticky floor" that Janaba reported on in the Updates thread: viewtopic.php?p=7145#p7145

Er'cana has the same issues as everywhere, but here very strongly atm ... The avi is walking without moving for a few seconds
(maybe 4 or 5) at the base of stairs and on ledges etc. ... I have a few pictures to show you some of the exact places where ...
Everything else went great in Er'cana ...

Spoiler

Is your issue similar to hers?

I assume this happened on the Minkata.65 version. Another update is being done this evening, so you might want to revisit that area in Er'cana to see if the issue has been corrected with the newest update.

[Chiro]

Thank you very much, Tai'lahr.

My problem is the same as a thing of janaba!
I updated Minkata66 yesterday (Japan time).
The problem did not happen anymore.